Magnetek Flex 12RS System Manuál s instrukcemi stáhnout pdf (Strana 22)

Flex 4EX System Instruction Manual

December 2012

19 of 39

4.1.5 I-CHIP

The I-CHIP functions in a way that is very similar to a SIM card inside a mobile phone, which

stores system information such as your telephone number, account number, phone book

and other settings. I-CHIP works exactly the same way, as it stores information such as

system serial number/ID code, channel and push button configurations.

When replacing a transmitter handset, just take the I-CHIP out of the old transmitter and

install it into the new one (refer to Fig. 11 below). For complete information transfer, make

sure both the Channel and Function dip-switch is set to all “1”. If both dip-switches are set to

all “1”, then the transmitter will operate according to the push button configurations and

channel stored inside the I-CHIP. If both Channel and Function dip-switch is set to other

values other than all “1”, then the transmitter will operate according to the channel and push

button configurations set on these two dip-switches, not the ones stored inside the I-CHIP.

Every time when the settings on these two dip-switches have changed, the new settings will

be stored into the I-CHIP automatically. In this case the previous channel and push button

configurations stored inside the I-CHIP will be replaced by the new settings.

For safety purposes, the system serial number/ID code stored inside the I-CHIP can not be

changed directly on the transmitter encoder board. Only channels and push button

configurations can be changed directly on the encoder board via Channel and Function dip-

switches. There are only two ways that you can change transmitter serial number/ID code: via

I-CHIP programming port located on the decoder module inside the receiver unit, (please refer

to page 28 on how to program the I-CHIP (serial number/ID code) via the receiver unit); or via

an external I-CHIP programmer or duplicator unit available from the factory. Please ask your

local dealers for assistance if your system requires serial number/ID code adjustments.

(Fig. 11)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Žádné komentáře

Magnetek Flex 12RS System Manuál s instrukcemi Strana 22