Magnetek Flex 12EX System Uživatelský manuál stáhnout pdf (Strana 31)

Page 30

CATCH

PITCH

4. Pitch & Catch Operating Procedure

To release control of the crane, press the “Pitch” push button. To take over control of the crane,

rotate the power key switch to “Catch” position for up to 2 seconds. The 2

operator “can not”

take control of the crane unless the 1

operator presses the “Pitch” push button (2.0 seconds). If

the operator unintentionally presses the “Pitch” push button during operation, just rotate the

power key to “Catch” position for up to 2 seconds to regain control again.

→ →

5. Automatic Channel Scanning Operating Procedure

After changing transmitter channel (refer to page 9), turn on the transmitter power and rotate the

power key switch to “Start” position and hold it there for up to 1 minute. Within this 1-minute

period the receiver will search (channel 01 ~ channel 62) and lock onto the newly selected

transmitter channel automatically. Please note that in order for the receiver to switch to

auto-scanning mode, prior to changing the transmitter channel, you must first deactivate the receiver

MAIN by shutting off the transmitter power or press down the emergency stop button. Please refer

to page 19 if you do not want the receiver to auto-scan all 62 channels.

Change Transmitter Channel →

6. Changing Transmitter Batteries

Changing transmitter batteries by unscrewing the battery cover located on the backside of the

transmitter (refer to Fig. 20 below). During battery installations make sure that the blue ribbon is

centered between the two batteries. After changing the batteries also make sure that all screws are

tightened to avoid water, moisture, dirt, grease, or other liquid penetration.

(Fig. 20)

↓

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Žádné komentáře

Magnetek Flex 12EX System Uživatelský manuál Strana 31