Magnetek Flex 12EX System Manuál s instrukcemi stáhnout pdf (Strana 41)

Flex 12EX System Instruction Manual

December 2013

Page 41 of 48

432 mm

Control

Panel

3. Ensure the selected location has adequate space to accommodate the

receiver (refer to Fig. 19 on page 40). If an external antenna is used, to

avoid the possibility of antenna damage always locate the receiver

where the antenna is free from any obstacles from all directions (refer to

diagram at right).

4. When installing an external antenna you must connect the SMA jack

located inside the receiver and make sure to set the jumper to “EXT”

position (refer to diagram below).

5. For better reception, make sure the receiver is in an upright position.

6. Drill two holes (10mm in diameter) on the control panel or location where the receiver is to be

installed (refer to Fig. 19 on page 40).

7. Make sure the two bolts are tightened after installation.

8. For system wiring please refer to page 39.

6.4 SYSTEM TESTING

1. Turn on the power source to the receiver and test the MAIN relay output by pressing the red

emergency stop button and observe that it properly opens and closes the mainline disconnect

contactor.

2. Test the operation of each function to ensure it corresponds to the transmitter direction labels or the

pendant it is replacing.

3. Test the limit switches (if any) to see if they are working properly.

4. If your new remote control is replacing an existing pendant, make sure it is completely

disconnected and placed in a safe location to prevent unwanted control commands.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Žádné komentáře

Magnetek Flex 12EX System Manuál s instrukcemi Strana 41