Magnetek Flex 12EX System Manuál s instrukcemi stáhnout pdf (Strana 45)

Flex 12EX System Instruction Manual

December 2013

Page 45 of 48

7.2 STATUS LIGHT INDICATORS & WARNINGS

7.2.1Transmitter STATUS Light Indication

Type Display Type Indication

Constant red

Voltage goes below 1.9V at initial power on -

transmitter power shuts off.

Voltage goes below 1.8V during operation -

transmitter power shuts off. Turn the power off

to disengage the receiver main.

1 red blink followed by a 2-

second pause

Voltage goes below 1.85V during operation -

change batteries immediately.

2 red blinks followed by a 2-

second pause

The pushbutton is defective after turning on the

transmitter power.

No light displayed

When a defective push button condition occurs

(2 red blinks, type 3 above), find out which push

button is defective by pressing all the push

buttons on the transmitter one at a time. If the

push button is in good working order, the LED

will not light up when pressed. If the push

button is defective the LED will continue to

display 2 red blinks when pressed.

3 red blinks followed by a 2-

second pause

EEPROM error.

4 red blinks followed by a 2-

second pause

Transmitting error, system can not lock on

to the designated channel.

Constant green for up to 2

seconds

Transmitter power on with no faults detected

(prior to initiating the START function).

Blinking green Pushbutton pressed, signal transmitted.

Slow red blinks

Stop command initiated with receiver

MAIN deactivated.

1 orange blink every 4 seconds Transmitter on standby.

1 2 ... 40 41 42 43 44 45 46 47 48

Komentáře k této Příručce

Žádné komentáře

Magnetek Flex 12EX System Manuál s instrukcemi Strana 45

Komentáře k této Příručce